Page 1 of 1
Hello from Las Vegas
Posted: Wed Nov 18, 2015 12:53 am
by Slimneverdies
Hello fellow welders and craftsman. I've lurk through Jody's website long enough and figured it was time to join the forums. I'm an open book and ready to hone my skills up a few notches. I usually mig weld but found myself addicted to looking at pics of pretty tig welds. I just purchased the Lincoln 200 square wave tig until I'm really in need for a bigger and better machine. Just want to get better...
Thanks
Slim
Re: Hello from Las Vegas
Posted: Wed Nov 18, 2015 7:18 am
by MosquitoMoto
Welcome along, Slim!
Kym
Re: Hello from Las Vegas
Posted: Wed Nov 18, 2015 7:18 am
by Fat Bob
Welcome Slim, hope you enjoy your stay. Any questions about your new found process just ask away.
There's a lot of talent here, someone will have an answer for ya.
Re: Hello from Las Vegas
Posted: Wed Nov 18, 2015 11:06 am
by soutthpaw
Welcome from a northern neighbor in Sparks.
Re: Hello from Las Vegas
Posted: Wed Nov 18, 2015 7:45 pm
by Slimneverdies
Thanks for the warm welcome everyone. I have many questions and ready to start asking.
Re: Hello from Las Vegas
Posted: Thu Nov 19, 2015 12:43 pm
by Mike
Welcome to the forum Slim.
Re: Hello from Las Vegas
Posted: Sun Dec 13, 2015 10:09 am
by LtBadd
Slimneverdies wrote:Hello fellow welders and craftsman. I've lurk through Jody's website long enough and figured it was time to join the forums. I'm an open book and ready to hone my skills up a few notches. I usually mig weld but found myself addicted to looking at pics of pretty tig welds. I just purchased the Lincoln 200 square wave tig until I'm really in need for a bigger and better machine. Just want to get better...
Thanks
Slim
Welcome Slim, there are some asking about that new Lincoln machine, it seems to be a nice unit on paper, I'm sure a review would be welcomed. If you decide to do so post it in the product review forum.
Richard
Re: Hello from Las Vegas
Posted: Sun Dec 13, 2015 10:49 am
by Poland308
Welcome.