Hi from minne soda
Posted: Tue Sep 01, 2015 8:17 pm
I am going to gain lots of good information and advise from this forum site! . I have a Miller TIG that is not hooked up yet ... ( it is HUGE, must weigh 500 pounds) also a Forney stick 230 amp I been using for 35 - 40 years , and a oxy acc ... I just bought a LOTOS 2000D 3 in 1 unit . should receive it next week. I also have some HVAC equipment .. gauges , reclaim equipment , etc (and a refrigerant license too )
for another interest I have a 48 inch metal turning lathe , a Bridgeport vertical mill etc. ....
I worked for 30 years at Honeywell , where I got very good at TIG welding Pt. wonderful stuff!! .....
you probably notice that I must be a bit older than most other members .... I will be 82 this month . wife an I been together 62 years now , with over 40 direct decendants (so far) ..... latest great grand son is a month old ..... (some greats are teenagers already) I plan to attempt some design / fab projects this winter ....
best to you all !
dddon
for another interest I have a 48 inch metal turning lathe , a Bridgeport vertical mill etc. ....
I worked for 30 years at Honeywell , where I got very good at TIG welding Pt. wonderful stuff!! .....
you probably notice that I must be a bit older than most other members .... I will be 82 this month . wife an I been together 62 years now , with over 40 direct decendants (so far) ..... latest great grand son is a month old ..... (some greats are teenagers already) I plan to attempt some design / fab projects this winter ....
best to you all !
dddon