Page 1 of 1
New member here!
Posted: Thu Dec 04, 2014 8:25 pm
by jrouse
Hey guys new member here, names Joe. Just recently started a welding program at Triangle Tech in Pittsburgh PA this past October. So far all I have dabbled in is Oxyfuel welding but will be starting intro to ARC tomorrow learning how to strike an ARC. Hope to pick up some helpful tips and tricks on here to keep ahead of the game at school! Looking forward to the extensive knowledge here! Thanks!
Re: New member here!
Posted: Thu Dec 04, 2014 9:47 pm
by Braehill
jrouse,
You have a few other members here from around Pittsburgh. This is a good place to find the answer to most any question you could have about welding or fabrication.
Welcome to the forum.
I'm from Lower Burrell, near New Kensington.
Len
Re: New member here!
Posted: Fri Dec 05, 2014 7:01 am
by motox
welcome to the forum
Re: New member here!
Posted: Fri Dec 05, 2014 9:57 am
by Mike
Welcome to the forum.
Re: New member here!
Posted: Fri Dec 05, 2014 2:56 pm
by jwright650
Hey Joe...welcome