Page 1 of 1

Newbeee - Aluminum Welder

Posted: Sun Feb 23, 2014 12:53 pm
by propdr
Hello, I am a new forum member and I am looking for information on welding some old automobile parts that are of what I would refer to as die cast aluminum. However, I believe this material has a content of zinc, aluminum and magnesium content. I am not sure of the percentages. Some one said it is or can be referred to as zamak or zamack not sure if this is even correct.
These parts are usually found on automobile door handles, steering column parts etc. Can anyone help with this?

Thanks,
Gary

Re: Newbeee - Aluminum Welder

Posted: Sun Feb 23, 2014 9:50 pm
by Superiorwelding
Gary,
Welcome to the forum! I posted one idea in the TIG section.

Re: Newbeee - Aluminum Welder

Posted: Mon Feb 24, 2014 1:21 am
by paul_s
Welcome to the forum.

Re: Newbeee - Aluminum Welder

Posted: Mon Feb 24, 2014 1:29 am
by AKweldshop
Welcome to the Forum Gary.

~John

Re: Newbeee - Aluminum Welder

Posted: Mon Feb 24, 2014 11:27 am
by Mike
Welcome to the forum Gary.