Old but, new
Posted: Sat Feb 22, 2014 6:35 am
Hello,
Just registered. I have been receiving Jody's videos for over 3 years or longer. Very informative. I have an old P&H heliarc welder that is now hooked up with an air cooled WP17 torch and I also have a MIG welder from Eastwood and it came with the spoolgun. I grew up with oxy/acetylene and my garage is now about set up to do some work. I have a '56 Chevy that I am going to do a frame off restoration. Lots of sheet metal to replace/repair. Now I have to start practicing. So, Hello everyone.
Paul
Just registered. I have been receiving Jody's videos for over 3 years or longer. Very informative. I have an old P&H heliarc welder that is now hooked up with an air cooled WP17 torch and I also have a MIG welder from Eastwood and it came with the spoolgun. I grew up with oxy/acetylene and my garage is now about set up to do some work. I have a '56 Chevy that I am going to do a frame off restoration. Lots of sheet metal to replace/repair. Now I have to start practicing. So, Hello everyone.
Paul