Page 1 of 1
Thank you from Ky.!
Posted: Thu Jan 09, 2014 4:12 pm
by Russellmania73
I finally registered. Thanks for your great instructional videos, as it is hard to find any for someone who is not a novice. Better than university level! I'll be looking for more. How about more on alloys; pre-heat, post-heat, technique?
Sand and slag
Posted: Thu Jan 09, 2014 4:15 pm
by Russellmania73
Anyone know of work avaiable in Florida's gulf coast region? I'm highly skilled in the piping and fabricating/structural fields!
Re: Sand and slag
Posted: Thu Jan 09, 2014 6:48 pm
by Otto Nobedder
Welcome!
I don't have any info right off the top of my head, but I'll pay attention for it on a FB group I'm in that's focused on the industrial trades.
Have you had a look on
www.roadtechs.com?
There's also a few pipe posts occassionally on
www.drywallflorida.com.
Steve S
Re: Thank you from Ky.!
Posted: Thu Jan 09, 2014 7:08 pm
by Mike
Welcome to the forum Russellmina73.
Re: Thank you from Ky.!
Posted: Thu Jan 09, 2014 7:33 pm
by AKweldshop
welcome to the forum
Re: Sand and slag
Posted: Thu Jan 09, 2014 8:51 pm
by Braehill
The company I work for had a listing for welders at what seems to be a new plant in Palmetto, Fla.
Check on their website airproducts.com under careers.
Len
Re: Sand and slag
Posted: Thu Jan 09, 2014 11:11 pm
by AKweldshop
Welcome to the forum, Russell?
Good to have you
John
Re: Thank you from Ky.!
Posted: Fri Jan 10, 2014 5:32 am
by weldin mike 27
Hey,
If you search through the youtube channel of wt&t, youll find a series of vids called metals and how to weld them, where jody talks about some different metals. Also one of his laterest vids was on low alloy steel, and he does quiteabit on cro-mo.
Mick
Re: Thank you from Ky.!
Posted: Fri Jan 10, 2014 9:35 am
by Fat Bob
Welcome to the site.