Page 1 of 1
new member intro
Posted: Fri Dec 06, 2013 5:25 pm
by grinder
Hey all,
I'm hobbyist type welder with a lot of interest in getting skilled enough with TIG (mild steel and stainless) so I can make safe and good looking welds.
Re: new member intro
Posted: Fri Dec 06, 2013 7:24 pm
by Otto Nobedder
Welcome, grinder,
You've found a good spot for help with your goal. I like that you put "safe" before "good looking". They're not necessarily the same thing. I've seen many welds that were one but not the other (and a handfull that were neither
).
We're all about sharing knowledge and experience, and there's a broad base of it here.
Steve S
Re: new member intro
Posted: Fri Dec 06, 2013 9:47 pm
by JoeC79
Hello. Just wanted to introduce myself because I am a noo here too.. Tell me about what you fabricate or weld in general. Always interested in what other people may know that I may not. And also always willing to share what works fo me.
Re: new member intro
Posted: Wed Dec 18, 2013 3:15 am
by AKweldshop
Welcome to the forum grinder
Re: new member intro
Posted: Wed Dec 18, 2013 3:44 pm
by Mike
Welcome to the forum grinder.