Page 1 of 1
Greetings from Brownsville,TX
Posted: Thu Oct 24, 2013 1:25 pm
by SAMBALLS1
I just took the plunge and purchased myself a Powertig 200DX.... I'm currently building a race car and need the tig machine to do some fabbing of parts needed for the car... I'm a noob... i've never touched a welder in my life... and am just about to unbox the machine and buy the neccessary stuff to get myself moving in the right direction..
Thanks
Sam
Re: Greetings from Brownsville,TX
Posted: Thu Oct 24, 2013 7:08 pm
by weldin mike 27
Awesome, welcome to the forum and to the trade. Have a look around your area for welding courses to give you a leg up with learning.
Mick
Re: Greetings from Brownsville,TX
Posted: Fri Oct 25, 2013 9:31 am
by Fat Bob
Welcome to the site Sam! If you are working with tubing on the car you might like this tube coping program.
http://metalgeek.com/static/cope_custom.pcgi. Plug in our numbers and print a paper pattern to notch your joint.
If you haven't already, be sure to check out Jody's videos. They are very informative and there's a button at the top of the page to take you there.
Re: Greetings from Brownsville,TX
Posted: Fri Oct 25, 2013 9:39 am
by Mike
Welcome to the forum Sam.