Page 1 of 1
Noobe just learning to TIG
Posted: Sat Apr 13, 2013 7:26 pm
by jrc413
Hello everyone! Im new to the forum and to TIG welding. Just purchased a Lincoln Precision TIG 225 and already its kicking my tail. Im sure I'll have lots of questions. Thanks for any help and advice along the way!
Re: Noobe just learning to TIG
Posted: Sat Apr 13, 2013 7:30 pm
by weldin mike 27
Hey ,
Welcome to the forum. Take it slow.
Mick
Re: Noobe just learning to TIG
Posted: Sun Apr 14, 2013 8:53 am
by Fat Bob
Glad to have ya jr. If your having trouble getting things to work out for ya stop by the Tig forum and post up your issue. Pictures of the problem always help others find the solution to get you on your way.
Welcome aboard!
edit: Oops, I see you've already been there.
Re: Noobe just learning to TIG
Posted: Mon Apr 15, 2013 8:49 am
by Mike
Welcome to the forum.
Re: Noobe just learning to TIG
Posted: Mon Apr 22, 2013 7:59 am
by aleezy
Nice surprise about this shorter form. Can you tell us what it is you are talking/writing about?
Has any info. about this shorter form been posted before (and i just missed it)?
Re: Noobe just learning to TIG
Posted: Mon Apr 22, 2013 10:08 am
by Alexa
aleezy wrote:Nice surprise about this shorter form. Can you tell us what it is you are talking/writing about?
Has any info. about this shorter form been posted before (and i just missed it)?
=====
Aleezy.
I do not understand the post.
You refer to a "shorter form".
Where was the wording "shorter form" used previously?
Tanks.
Alexa
Re: Noobe just learning to TIG
Posted: Mon Apr 22, 2013 5:33 pm
by Otto Nobedder
Welcome, aleezy,
Translation issue? "Shorter Forum", maybe? Meaning this group as an adjunct to WT&T?
If so, then yes, Jody has mentioned this forum in at least one of his videos.
Steve S