Been watching Jody’s videos for awhile now and finally joined the forum yesterday. I’ve been practicing hard for the last several weeks in anticipation of a project I have going on. I’ve owned a welder for the past 15 years but have burned more wire, cut more coupons and cut/etched more tests in the last 4 weeks than 15 years!
Looking forward to getting some good advice.
Welcome from North Carolina. When you get started on your upcoming project, post a few pictures.
Lance
Lance
LanceR
Miller Multimatic 255
Hypertherm Powermax45 XP
Heck Bevel Mill 4000
Ace fume extractor
Welding/cutting/brazing torches
Miller Multimatic 255
Hypertherm Powermax45 XP
Heck Bevel Mill 4000
Ace fume extractor
Welding/cutting/brazing torches