Page 1 of 1
First Post
Posted: Sun Nov 18, 2018 8:55 pm
by Lee
Hello,
This is my first Post.
I'm interested in a welding table. A 2 x 4 Certiflat table looks interesting. Any one have experience with this?
Also where would I look for a kit of clamps that would work well with this table
Thanks
Re: First Post
Posted: Mon Nov 19, 2018 6:34 am
by cj737
Strong Hand Tools “Inserta” clamps.
Re: First Post
Posted: Mon Nov 19, 2018 7:23 am
by tungstendipper
Welcome!
My cert-flat table is one of the best thing I have bought for my shop! I haven't found anything I haven't been able to clamp down to weld. As far as clamps, make your own. Harbor Freight has what you need and it a good start. You just need to buy 1 1/2" X 3/16" flat stock and 5/8" round cold rolled and you're off to the races!
Re: First Post
Posted: Mon Nov 19, 2018 10:47 am
by tungstendipper
Here's my latest prototype clamp (modeled after Fireball Tool's clamp) used to reach areas where this clamp wouldn't reach.
Re: First Post
Posted: Wed Nov 21, 2018 4:47 pm
by Lee
Thanks guys. your responses were very helpful !
Re: First Post
Posted: Fri Nov 30, 2018 3:22 am
by JeffDarby
Welcome to the forum,
Re: First Post
Posted: Fri Nov 30, 2018 3:23 am
by JeffDarby
tungstendipper wrote:Welcome!
My cert-flat table is one of the best thing I have bought for my shop! I haven't found anything I haven't been able to clamp down to weld. As far as clamps, make your own. Harbor Freight has what you need and it a good start. You just need to buy 1 1/2" X 3/16" flat stock and 5/8" round cold rolled and you're off to the races!
Nice table, im building mine now, it will be a bit rough but functional.