Welding Tips and Tricks

Im from Seattle Im currently working at a dairy equipment manufacturing company and am looking to step my welding skills up especially in the areas of TIG/MIG. Any information that allows me to further my knowledge would be extremely helpful. Specifically in the area of WFS/IPM and Voltage settings for carbon steel on 1/8 to 1/4 in." in all positions using the GMAW/MIG process. I would really appreciate specific tricks used in order to properly set your machine.
Prior to getting back into welding about 2 months ago I was mainly on prep work, however i have been welding sense 16 just rusty and would appreciate any and all advice and knowledge that will allow me to excel at this opportunity.
Thanks for the time!

Welcome.

Typically, those parameters are guided by the machine you're using. Perhaps if you listed what equipment you're working with, a chart can be linked for you.