Welcome to the community! Tell us about yourself, your welding interests, skills, specialties, equipment, etc.
(very) Amature welder get TIG machine...
Post Reply
Neosec
  • Posts:
  • Joined:
    Wed Jun 14, 2017 8:26 am
  • Location:
    PA

Hello everyone,
I recently bought a Thermal Arc 186 TIG welder. I've never TIG welded before getting this machine. I've been pouring over YouTube videos to learn some technique and have completed my first project, but not without several failures. Primarily welding 6160 aluminum so far.
Looking forward to your constructive criticism, tips and feedback.

Regards,
Neosec
Top
cj737
  • Posts:
  • Joined:
    Thu Sep 29, 2016 8:59 am

Aluminum is very hard to learn to TIG weld straight away. I'd encourage you to start with steel, get some skills there, then switch to aluminum. But it's possible with enough practice, Argon, and plenty of patience.
Top
Mike
  • Posts:
  • Joined:
    Mon Dec 06, 2010 1:09 pm
  • Location:
    Andover, Ohio

Neosec, welcome to the forum.
M J Mauer Andover, Ohio

Linoln A/C 225
Everlast PA 200
Top
Bill Beauregard
  • Posts:
  • Joined:
    Thu Jan 24, 2013 9:32 pm
  • Location:
    Green Mountains of Vermont

I did it the hard way. I had my heart set on some aluminum projects, so I tried steel a bit, then went to aluminum. It's easier to weld steel first. Jumping straight to al is a baptism of fire. Good luck. I've been there myself not long ago. Watch Jody's videos, Bob Moffat, and ask questions on forums. It'll come pretty fast.

Willie
Top
Post Reply

Return to “Member Introductions”