New member
Posted: Mon Apr 24, 2017 9:30 am
Hello all! I just signed up and have a stainless welding question. I'm going to keep this an introductory post though, and will try to find the right spot to park my question.
I am a car guy and aspiring fabricator. About 12 years ago I found myself in a sales/management position and not completely satisfied. I found the show "Monster Garage" and was inspired to buy a welder. These days I own a German car specialty shop that has grown into a decent sized business, doing mainly dealer-alternative type work. Through the years I have taken on some rust repair and restoration work along with some small fabrication projects. . I have built a little fab room into my business, and continue to build my skills when I have the time. I make some furniture, scrap-sculpture, etc.
Not sure that I'll be a huge conmtributing member to the forum, but I'll try to drop by from time to time.
I am a car guy and aspiring fabricator. About 12 years ago I found myself in a sales/management position and not completely satisfied. I found the show "Monster Garage" and was inspired to buy a welder. These days I own a German car specialty shop that has grown into a decent sized business, doing mainly dealer-alternative type work. Through the years I have taken on some rust repair and restoration work along with some small fabrication projects. . I have built a little fab room into my business, and continue to build my skills when I have the time. I make some furniture, scrap-sculpture, etc.
Not sure that I'll be a huge conmtributing member to the forum, but I'll try to drop by from time to time.