Page 1 of 1

New Member

Posted: Thu Dec 01, 2016 12:37 pm
by Chips O'Toole
I'm new so I'm posting an introduction.

I have been welding since 2007, but I do very little of it, so I classified myself as a beginner. My only welding equipment is a Lincoln 180C. I also have a nice plasma cutter, because, well, sawing is for the little people.

Hope I can make a positive contribution to the forum.

Re: New Member

Posted: Thu Dec 01, 2016 5:23 pm
by MosquitoMoto
Chips O'Toole wrote:I'm new so I'm posting an introduction.

I have been welding since 2007, but I do very little of it, so I classified myself as a beginner. My only welding equipment is a Lincoln 180C. I also have a nice plasma cutter, because, well, sawing is for the little people.

Hope I can make a positive contribution to the forum.

Chips, between your username and 'sawing is for the little people' I am liking you already.

Welcome.



Kym

Re: New Member

Posted: Thu Dec 01, 2016 7:28 pm
by Chips O'Toole
Chips, between your username and 'sawing is for the little people' I am liking you already.

Welcome.



Kym
Thanks.

I just can't see the logic in taking 3 minutes to cut something with a grinder when I can take 15 minutes to set it up and vaporize it with hot plasma.

Re: New Member

Posted: Thu Dec 01, 2016 8:43 pm
by hcspeed
Chips O'Toole wrote:I'm new so I'm posting an introduction.

I have been welding since 2007, but I do very little of it, so I classified myself as a beginner. My only welding equipment is a Lincoln 180C. I also have a nice plasma cutter, because, well, sawing is for the little people.

Hope I can make a positive contribution to the forum.
dayum , don't be dissin my circa 1983 17lb Millwalke sawzall.

Re: New Member

Posted: Fri Dec 02, 2016 9:04 am
by Mike
Chips, welcome to the forum.

Re: New Member

Posted: Sat Dec 03, 2016 1:39 pm
by cherwolf
Commcheck.