mister_fixit
- mister_fixit
-
New Member
-
Posts:
-
Joined:Sat Jun 25, 2016 9:11 am
-
Location:Western New York
Hello all, I just love doing things myself and I love learning new things. So when my 10' X 6' dump trailer needed a new floor because of rust thru and my sisters husband pass away who was a union pipe welder I thought, we have the equipment, all I have to do is learn to us it. I have been watching Jody's videos non stop and have learned a lot. I did a little mig welding (need a lot of practice) and cant wait to try my hand at tig. I have had an Ocy/ Acy outfit for many years so two handed welding is not new to me, we shall see. So that's my project for now, wish me luck. I'm sure I will have many questions as I get going.
David
Lincoln ST170T Mig
Everlast PowerUltra 205P
Lincoln Idealarc 250
Lincoln ST170T Mig
Everlast PowerUltra 205P
Lincoln Idealarc 250
mister_fixit
- mister_fixit
-
New Member
-
Posts:
-
Joined:Sat Jun 25, 2016 9:11 am
-
Location:Western New York
Thanks. I have been following this forum for a while and found a lot of good advice and helpful people.
David
Lincoln ST170T Mig
Everlast PowerUltra 205P
Lincoln Idealarc 250
Lincoln ST170T Mig
Everlast PowerUltra 205P
Lincoln Idealarc 250
GreinTime
- GreinTime
-
Weldmonger
-
Posts:
-
Joined:Fri Nov 01, 2013 11:20 am
-
Location:Pittsburgh, PA
If you can torch weld, TIG welding won't be a far stretch for you to pick up.mister_fixit wrote:Thanks. I have been following this forum for a while and found a lot of good advice and helpful people.
Sent from my SM-G900V using Tapatalk
#oneleggedproblems
-=Sam=-
-=Sam=-