h53mechanic
- h53mechanic
-
New Member
-
Posts:
-
Joined:Wed Sep 17, 2014 9:53 am
-
Location:Corpus Christi Texas
I have this old wire feeder and I like it very much; however, there is not much information on this machine. Does anyone have an old manual or maybe .045/.035 flux core wire drive wheel? I would like to know more background information about this machine.
- Attachments
-
- Airco (10).jpg (53.8 KiB) Viewed 755 times
-
- Airco (9).JPG (51.01 KiB) Viewed 755 times
-
- Airco (8).JPG (43.45 KiB) Viewed 755 times
-
- Airco (7).JPG (44.24 KiB) Viewed 755 times
-
- Airco (6).JPG (55.76 KiB) Viewed 755 times
-
- Airco (5).JPG (55.27 KiB) Viewed 755 times
-
- Airco (4).JPG (47.16 KiB) Viewed 755 times
-
- Airco (3).JPG (56.3 KiB) Viewed 755 times
-
- Airco (2).JPG (49.54 KiB) Viewed 755 times
-
- Airco (1).JPG (47.88 KiB) Viewed 755 times
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
Have you considered taking your drive wheels to a machinist? Have a new set made, using the groove specifications for a similar Miller welder? (Since Airco and Miller are, to my knowledge, essetially the same, separated by time?)
In lieu of any help for manuals or "new-old-stock parts", this is an option.
Have patience, though. If parts or manuals still exist/are available, someone here will be able to point you in the right direction.
Welcome to the zoo!
Steve S
In lieu of any help for manuals or "new-old-stock parts", this is an option.
Have patience, though. If parts or manuals still exist/are available, someone here will be able to point you in the right direction.
Welcome to the zoo!
Steve S