I am a long time hot rodder and restorer and I am currently building a '53 BelAir convertible which is missing the bottom 6 inches.
Lots of welds to grind in the next few months.
John
I was advised of this forum and site by DeadBodyaman, another new member. I am excited to have the opportunity to learn from those who are wiser than I am. I own and use MIG, O/A, and recently a plasma cutter but have only limited experience with TIG. My hopes are to change that in the future.
I am a long time hot rodder and restorer and I am currently building a '53 BelAir convertible which is missing the bottom 6 inches.
Lots of welds to grind in the next few months.
John
I am a long time hot rodder and restorer and I am currently building a '53 BelAir convertible which is missing the bottom 6 inches.
Lots of welds to grind in the next few months.
John
Slow but willing learner
- AKweldshop
-
Weldmonger
-
Posts:
-
Joined:Wed Oct 23, 2013 3:30 pm
-
Location:Palmer AK
Welcome to the Forum John 
My names John too
Good to have you
Welcome Aboard
John
My names John too
Good to have you
Welcome Aboard
John
Just a couple welders and a couple of big hammers and torches.
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024