Eric in Sf ,
Been welding for about 10 years after taking classes at local college on welding , I took every class I could take on the subject of welding and metal trades ( Machine shop) but I came to a point where the school was a great starting point but they had very limited resources .
I am looking to learn more about pipe welding
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
Welcome, Eric,
We can't "show" you how we each do it (and no two do it alike),
But you can ask anything here, and expect a reasonable answer.
Steve S
We can't "show" you how we each do it (and no two do it alike),
But you can ask anything here, and expect a reasonable answer.
Steve S
- AKweldshop
-
Weldmonger
-
Posts:
-
Joined:Wed Oct 23, 2013 3:30 pm
-
Location:Palmer AK
Eric, welcome to the forum
always something to learn....
good luck....
John
always something to learn....
good luck....
John
Just a couple welders and a couple of big hammers and torches.
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Welcome to our little corner of the internet Eric.
Have you seen Jody's weekly videos? One he did last week was 6G Pipe with 6010. Just the root pass last week. I think he said 7018 for the cap, maybe this week. His videos are always very informative. Archive link at the top of any page.
Have you seen Jody's weekly videos? One he did last week was 6G Pipe with 6010. Just the root pass last week. I think he said 7018 for the cap, maybe this week. His videos are always very informative. Archive link at the top of any page.
Go break something, then you can weld it back the right way.
