I'm Cristian. My welding experience is comprised of 20 minutes with a stick welder, which was fun, and around 2 hours with a spool gun "trying" to weld some aluminum, which was fairly ugly. And since then I've been wanting a AC Tig machine, just haven't had a good reason to get one until my current project.
Anyway, I'm about to purchase a Tig setup but had one specific question before pulling the trigger, so I started to look for a bulletin board only to find out that Jody has one.
Like most of you, I've been watching a lot of his videos and found a wealth of information. Thank you, Jody!
I look forward to talking to some of you fine people!
Cheers!
BillE.Dee
- BillE.Dee
-
Weldmonger
-
Posts:
-
Joined:Mon Nov 27, 2017 8:53 pm
-
Location:Pennsylvania (Northeast corner)
Hello Cristian and welcome. It would be helpful if you could post where you are located as different areas of the world have different machines that would fit your needs. Enjoy the forum and the wealth of knowledge that is available.
gramps
gramps
