Page 1 of 1
wire feed rollers
Posted: Sun Feb 14, 2021 9:22 pm
by Deano56
I have 2 wire feed rollers .030 and .035 for free plus shipping. They are square drive not round with keyway. I ordered off of ebay and they sent these instead of what I ordered. They might fit the small Lincoln welders I believe
Re: wire feed rollers
Posted: Sun Feb 14, 2021 10:36 pm
by PacoG817
Do you think they would fit the ln-25 wire feed machine?
Re: wire feed rollers
Posted: Wed Feb 24, 2021 7:38 pm
by Deano56
PacoG817 wrote:Do you think they would fit the ln-25 wire feed machine?
I don't know what that welder is?
Re: wire feed rollers
Posted: Wed Feb 24, 2021 7:44 pm
by Deano56
Deano56 wrote:PacoG817 wrote:Do you think they would fit the ln-25 wire feed machine?
I don't know what that welder is?
I looked that welder up, it shows a round bore with a keyway, I state what I have is square drive. Take a look at yours to make sure
Re: wire feed rollers
Posted: Sun Nov 28, 2021 3:24 pm
by Supersoaker
My lincoln ln-22 has a square shaft that the drive rolls are attached to! Are these still available?