Page 1 of 1
Fronius welders
Posted: Fri Jun 20, 2014 6:44 pm
by KEJ76
Jody this question is for you or for anyone who has information about Fronius welders. I'm looking to buy a used Fronius Transpulse Synergic 4000 and I would like to get any info I can about these welders! So if anyone has any input, please share!!!
Re: Fronius welders
Posted: Sat Jun 21, 2014 4:26 am
by Evgen
KEJ76 wrote:I'm looking to buy a used Fronius Transpulse Synergic 4000 and I would like to get any info I can about these welders! So if anyone has any input, please share!!!
Even if you are going to buy a combine, you are going to use some type of weld more then others. Transpulse Synergic is mainly MIG/MAG weld. It hasn't detailed settings for MMA and moreover for TIG.
As for MIG/MAG weld, it has standard programs for some steels, alloys, wires and gases, but it's not enough, and synergic mode isn't always useful.
I had Transpulse Synergic 2700, but I used it only as MIG/MAG for definite processes, and mostly in the manual mode(without using standard programs).
But it's only my humble opinion.
Re: Fronius welders
Posted: Mon Jun 23, 2014 2:40 pm
by Jared
Although we dont have any Fronius units at work , i have used them before.....In the UK they are respected very highly for there pulsed aluminium mig machines.......Talking to the engineer we use for repairs and callibration the only downside can be getting spares though...