Page 1 of 1
Reapir pot metal
Posted: Mon Apr 28, 2014 10:47 pm
by jcvweldinspect
I am looking for the best way to repair pot metal, can you tig weld it or should a person just look at brazing it.
Re: Reapir pot metal
Posted: Mon Apr 28, 2014 11:03 pm
by Otto Nobedder
Welcome.
I saw an episode of"powerblock tv" featuring a shop that repaired pot-metal parts for chroming. They used primarily TIG.
I'll try to look it up tomorrow.
Steve S
Re: Reapir pot metal
Posted: Tue Apr 29, 2014 12:01 am
by Superiorwelding
jcvweldinspect wrote:I am looking for the best way to repair pot metal, can you tig weld it or should a person just look at brazing it.
Welcome to the Forum! Can you tell us what it is or do you know what kind of pot metal it is?
-Jonathan
Re: Reapir pot metal
Posted: Tue Apr 29, 2014 6:40 am
by paul_s
Welcome to the forum.
Re: Reapir pot metal
Posted: Tue Apr 29, 2014 8:54 am
by Mike
Welcome to the forum jcvweldinspect.
Re: Reapir pot metal
Posted: Tue Apr 29, 2014 12:57 pm
by jcvweldinspect
It was a hyd handle around 18 inches long and 1.5 in thick, just reaching for some successful ideas.
Re: Reapir pot metal
Posted: Tue Apr 29, 2014 1:03 pm
by Antorcha
Quit with the "welcome" bolchit. Nobody cares.
Go to :
https://www.muggyweld.com/
The dude has you covered
Re: Reapir pot metal
Posted: Tue Apr 29, 2014 1:46 pm
by AKweldshop
https://www.youtube.com/watch?v=jijW310xvp4
I always likes this stuff....
Worked good for some misc aluminum sheet metal I did.
Spendy.