Welding Tips and Tricks

Posted: **Mon Apr 07, 2014 4:15 pm**

Here is a comparison between 6013, 7016, and 8016 cot and etched.
Don't laugh at the 8016 run, I had a sneezing fit half way along lol

: 20140407_100711.jpg (50.24 KiB) Viewed 404 times

: 20140407_144953.jpg (25.11 KiB) Viewed 404 times

The 6013 is far left, and as expected it has less penetration, mainly because the plate was not pre heated, whereas the 8016 run was done last when the plate was hot, maybe I shall try again but let the plate cool down between passes

Posted: **Mon Apr 07, 2014 11:26 pm**

Very nice. Can you weld three different coupons with the same settings and compare them? This way you won't have to wait for your substrate to cool down.
-Jonathan

Posted: **Tue Apr 08, 2014 2:52 am**

On hindsight, that is what I should have done

If I get a spare few minutes I'll have another go today

Andy

Welding Tips and Tricks

cut and etch, rod comparison

cut and etch, rod comparison

Re: cut and etch, rod comparison

Re: cut and etch, rod comparison