General welding questions that dont fit in TIG, MIG, Stick, or Certification etc.
Post Reply
User avatar
  • Posts:
  • Joined:
    Mon Jan 02, 2012 3:46 pm
  • Location:
    Bensalem, PA

Does any one know how to reset (to zero) the five programmable parameters in this machine?

Thanks
User avatar
  • Posts:
  • Joined:
    Thu Jan 06, 2011 11:40 pm
  • Location:
    Near New Orleans

If the control computer is the same, page 26 of this manual:

http://victortechnologies.eu/IM-Uploads ... Manual.pdf

explains adjusting the hidden parameters, as well as restoring factory defaults.

EDIT: Here should be the correct manual:

http://victortechnologies.com/IM_Upload ... 0X4861.pdf

If this is the right one, it looks like you'll have to enter the factory settings (section 4 pg 6) manually and save them as a "program", table 4-6 (section for page 8).

Hope this helps.

Steve S
User avatar
  • Posts:
  • Joined:
    Mon Jan 02, 2012 3:46 pm
  • Location:
    Bensalem, PA

Thanks again for your expertise!

Mike :mrgreen:
User avatar
  • Posts:
  • Joined:
    Thu Jan 06, 2011 11:40 pm
  • Location:
    Near New Orleans

Mike, I added another edit, with page references for the second manual. I hope it helps.

Steve S
User avatar
  • Posts:
  • Joined:
    Mon Jan 02, 2012 3:46 pm
  • Location:
    Bensalem, PA

Steve,

Those factory default settings listed are EXACTLY what I was looking for...
Thanks a million!



Mike
User avatar
  • Posts:
  • Joined:
    Thu Jan 06, 2011 11:40 pm
  • Location:
    Near New Orleans

Mike,

I'm glad I could help. For future searches, I'll tell you I had a headache finding this... Had to go back to an older name for the company's products, "thermadyne". An appropriate name... meaning "change in temperature". :lol:

Steve S
Post Reply