Page 1 of 1
Certi-flat 3x4 Pro Top kit x 2
Posted: Sun Jun 12, 2022 4:35 pm
by Oscar
Don't ask me a bunch of questions! (Ruark, circa April 2022
)
Yes over-clamped, but not enough clamps is not enough clamps.
I bought two, so I can use them side-by-side as a 4 x 6, but when I don't need that much area, I can just use one as a 3 x 4.
Re: Certi-flat 3x4 Pro Top kit x 2
Posted: Wed Jun 15, 2022 11:25 am
by bap_
Nice, those tables look slick
Re: Certi-flat 3x4 Pro Top kit x 2
Posted: Mon Jul 04, 2022 12:22 pm
by Oscar
Still working on making the stand, but the tables are done. I have about ±0.008
per 12" on the diagonal, which was the worse offender; there were two "bumps" that were quite difficult to get minimize. Along the 4ft lengths, it is better than that, and the short 3ft sides even better, by about 0.001" less. Better than the manufacturer spec of 0.015" per 12". I only tacked the slats on the underside (along the entire lengths), not the top where the tab-and-slot meet. I didn't want to risk having those warp it since I'm satisfied with how the flatness turned out.
