General welding questions that dont fit in TIG, MIG, Stick, or Certification etc.
User avatar
  • Posts:
  • Joined:
    Thu Dec 01, 2016 12:30 pm
  • Location:
    FL

Does anyone here know which gas supplier in the area of Marion County, Florida, is the best? I'd rather not find out by trial and error.

I use owner tanks.
I was socially distant before it was cool.
User avatar

If no one lives close enough to provide personal experience.

Walk in and start a conversion, I see only AirGas and Matheson, and a place called Chets Welding which may or may not be a supply house. Link HERE
Richard
Website
User avatar
  • Posts:
  • Joined:
    Tue Dec 13, 2016 9:24 pm
  • Location:
    Clearwater Florida

I use airgas exclusively.

because I'm special.
if there's a welder, there's a way
User avatar
  • Posts:
  • Joined:
    Thu Dec 01, 2016 12:30 pm
  • Location:
    FL

I ended up using Airgas. While I was there, I asked about their policies, and they said they would swap any size owner tank. That was good news.
I was socially distant before it was cool.
User avatar
  • Posts:
  • Joined:
    Thu Dec 26, 2013 12:41 am
  • Location:
    Laredo, Tx

That's good because a lot of Airgas' are super strict in other areas of the country.
Image
Post Reply