I recently saw the video of "Mig like Tig" and was wondering if this is something you were trying to achieve? Or am I even close myself? Thanks for the feedback.
God bless, Austin.
Hello,
I recently saw the video of "Mig like Tig" and was wondering if this is something you were trying to achieve? Or am I even close myself? Thanks for the feedback.
God bless, Austin.
I recently saw the video of "Mig like Tig" and was wondering if this is something you were trying to achieve? Or am I even close myself? Thanks for the feedback.
God bless, Austin.
- Attachments
-
- I'm sorry about the picture being flipped sideways.
- 20150305_135037.jpg (51.57 KiB) Viewed 1176 times
Last edited by ATubbin7 on Thu Jun 25, 2015 9:36 pm, edited 1 time in total.
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
Yes, Austin,
That was the general idea on that post.
There was much debate on strength comparisons between a constant-speed run versus the step-pause needed to make a weld like that without a "pulse-enabled" machine.
There was little consensus, as each approach can be done in differing ways.
Opinion follows:
If rated strength is required, a smooth constant rate bead with appropriate settings and angles will outperform a "step/pause" method, for more constant penetration and fewer stress risers in the deposited metal.
Steve S
That was the general idea on that post.
There was much debate on strength comparisons between a constant-speed run versus the step-pause needed to make a weld like that without a "pulse-enabled" machine.
There was little consensus, as each approach can be done in differing ways.
Opinion follows:
If rated strength is required, a smooth constant rate bead with appropriate settings and angles will outperform a "step/pause" method, for more constant penetration and fewer stress risers in the deposited metal.
Steve S
- AKweldshop
-
Weldmonger
-
Posts:
-
Joined:Wed Oct 23, 2013 3:30 pm
-
Location:Palmer AK
That second picture is gorgeous.
Just a couple welders and a couple of big hammers and torches.
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
- TRACKRANGER
-
Weldmonger
-
Posts:
-
Joined:Wed Aug 06, 2014 12:48 am
-
Location:Melbourne, Australia
It's hard to disagree with that. Real nice, for sure.AKweldshop wrote:That second picture is gorgeous.
EWM Phonenix 355 Pulse MIG set mainly for Aluminum, CIGWeld 300Amp AC/DC TIG, TRANSMIG S3C 300 Amp MIG, etc, etc
I was taught a technique by my first welding boss 30 yr ago how to fill gaps onsite with a stick.
Drag the arc well forward so as to let the puddle cool a wee bit then roll back into it. After watching vid I started pissing around at work with the MIG and pretty much got close to what the guy with the grouse workshop does. Try it, take the arc well forward and do a loop or whatever gives you a mongrel. My 2 bob.
Browny
Drag the arc well forward so as to let the puddle cool a wee bit then roll back into it. After watching vid I started pissing around at work with the MIG and pretty much got close to what the guy with the grouse workshop does. Try it, take the arc well forward and do a loop or whatever gives you a mongrel. My 2 bob.
Browny