MadisonRods
- MadisonRods
-
New Member
-
Posts:
-
Joined:Tue Jan 13, 2015 12:29 pm
Love the tig finger but I was always adjusting it. I added some Scotch glass cloth electrical tape (Good to 356 degrees) to the finger after it was adjusted and now it stays together.
- Attachments
-
- IMG-20150111-00523.jpg (38.55 KiB) Viewed 1203 times
-
- IMG-20150111-00522.jpg (38.87 KiB) Viewed 1203 times
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
That's using your noodle!
I use the XL, and change which finger(s) it's on regularly, so I'm always adjusting mine, but for the standard tigfinger, used the same way most of the time, that would solve a headache for sure.
I haven't tried it yet, but I'm considering putting a strip of friction tape inside mine so it stays in place as I change positions and prop points.
Steve S
I use the XL, and change which finger(s) it's on regularly, so I'm always adjusting mine, but for the standard tigfinger, used the same way most of the time, that would solve a headache for sure.
I haven't tried it yet, but I'm considering putting a strip of friction tape inside mine so it stays in place as I change positions and prop points.
Steve S