Post your ideas, suggestions and support issues here.
Citroën
  • Posts:
  • Joined:
    Mon Mar 12, 2012 1:35 pm
  • Location:
    Denmark

When I try to enter User Control Panel > Board Preferrences > Edit posting defaults i get this error;
General Error
Module not accessible
Migatronic Automig 233 MPS
Migatronic Sigma² 400 Pulse CW
Migatronic Pilot 2400 HP
User avatar
  • Posts:
  • Joined:
    Fri Apr 01, 2011 10:59 pm
  • Location:
    Australia; Victoria

Hey,

Same for me. Can you send an email to the address shown on the error page and let them know please.

Mick
Citroën
  • Posts:
  • Joined:
    Mon Mar 12, 2012 1:35 pm
  • Location:
    Denmark

weldin mike 27 wrote:Hey,

Same for me. Can you send an email to the address shown on the error page and let them know please.

Mick
Will do in a second :)

EDIT: Mail sent..
Migatronic Automig 233 MPS
Migatronic Sigma² 400 Pulse CW
Migatronic Pilot 2400 HP
User avatar
  • Posts:
  • Joined:
    Sun Feb 17, 2013 1:30 pm
  • Location:
    Colorado

Guys, I let the Admin know about this a week ago and it is being worked on. :)
Go break something, then you can weld it back the right way.

Image
Citroën
  • Posts:
  • Joined:
    Mon Mar 12, 2012 1:35 pm
  • Location:
    Denmark

Fat Bob wrote:Guys, I let the Admin know about this a week ago and it is being worked on. :)
Superb :)
Migatronic Automig 233 MPS
Migatronic Sigma² 400 Pulse CW
Migatronic Pilot 2400 HP
BDoubleU

Sorry for the error! We have a few maintenance items in the cue to be worked on. Hope to have that resolved soon - along with an updated search feature. Thanks for your patience as we make these updates.
weldfusion.com
User avatar

Citroën wrote:When I try to enter User Control Panel > Board Preferrences > Edit posting defaults i get this error;
General Error
Module not accessible
Happy to report that after much trial and error, this issue has been fixed. Thanks everyone for your patience. As always, feel free to reply if it continues to give you trouble.

Thanks,
Post Reply