Tamjeff,

All I can say is wow...great work

Looking good! Did you "walk the cup" on that bead?

Thanks guys! Ran the boat this weekend and everything held like it should've.

Sorry. I was reading more on it and it has the "blue lightening" technology

No sir. The Welding area was far enough away from any seals that I didn't have to worry about it much. Although I was still cautious only welding a little at a time to keep from getting to hot. Alot of carbon type stuff seemed to burn from the cast aluminum. I would stop clean and weld again. I did ...

No sir it's not

I have a Miller Dynasty 280 DX. It sometimes arcs from over 1/2" out. This is without pushing on the pedal much.

Well I broke my anti cavitation plate pulling my lower unit off to change the water pump...left a bolt in on underside up anode (imagine that). And I've changed them many times. Anyways figured why not try to fix it. Eventhough I've never tigged aluminum much less cast aluminum. Well it turned out l...

Looks great Tamjeff!

Decent penetration I think?

Thanks for the kind words. Will do...

I cleaned up the next piece like yall said and it was ALOT smoother. Other than where I had a couple of tacks at....

Thanks a lot for the advise!! Will do

Thanks. I know I have a ways to go. On this particular weld i had some scrap that I cut then just wire brushed it and wiped with acetone.

Hello everyone, this is my first post with pics on my attempts of learning to tig weld. Practice #1 1_T-Joint Practice _072615.JPG 1_T-Joint Practice _072615.JPG Practice#2 2A_T-Joint Practice_072615.JPG Welding with a Dynasty 280 DX_3/32 Filler 702s_149 Amps with foot pedal. I am trying to become m...

Looks good Trackranger

Another job well done!

Mike and Boomer, Thanks for the hospitality!

Thanks Craig! I know I will have plenty of questions.

Hello All! My name is Travis from Texas, live approximately 70 miles West of Houston. I see alot of great projects on here! I am learning to Tig weld now and eventually want to get into welding aluminum for recreational marine applications. Just wanted to introduce myself and say Hello.