any comments guys?

Please see attached picture

I would appreciate if you can give the exact model#
thanks!

Hi,

What is the best polishing tool for 18mm and 25mm inside diameter corner?

Hi Steve,

can you list the equipments you have?

thanks

Hi Guys,

I'm not sure if I am in the right area, but can you help me list all of the polishing tools that a fabricator should have?
we are having trouble on some areas that we cant fully polish.(hard to reach areas, narrow, reversed corner)

thanks!

hi jonathan, Thanks for the reply wont wet rag make the weld brittle? Im placing a aluminum bracket fro clamping for the lower part and series of thin copper plate on the base. i will then placed a angle bars for stiffeners in the base(tacked welded ). and just have it removed and polished afterwards.

Hi Rick,

Thanks for the reply
I have been reading some articles regarding welding distortion, and im thinking of using stiffeners and combination of heat sinks such as copper plate. (but as of now, i only have 0.9 copper plate)

Hi Guys, I have trouble in welding distortion in our fabrication. (waving) basically, we are fabricating clean room equipments Imagine a box which 6ft in length and 4ft width the box is being full weld at the lower front and back and causes the base to wave (see attached file) we are using 2mm stain...