i agree with admin. you should think about your tungsten electrode. i think you should try out the .040 mm red point for low amperage. and you should be fine, do 100%argon too.

best of luck you´ll get there. i love body work too.

mainly offroad

I THINK I SHOULD TRY IT MYSELF, AND SORRY FOR PUTTING ACEP SORRY ITS AC ONLY

BUT REMEBER THAT AC HALF THE TIME OF THE 60 HZ ITS OFF, HENCE A COLDER WELD. AND WHAT ABOUT PENETRATION DO YOU SPECIALLY NEED IT OR NOT, CORRECT PARAMETER ITS BETWEEN 60 AND 90 AMPS. FOR 3/32 308 STAINLESS.

ARE YOU CONSIDERING NEW ONE? OR 250 USED CAUSE I BELIEVE THE ONLY SYNC AVAILABLE NOW IS THE 250 DX OR THE 200 SYNC.

NO SIR NO DIFFERENCE, ONLY THAT YOUR FLOWMETER HAS TO ALLOW AT LEAST 4000 PSI INLET. AND THE FLOWMETER TOWER HAS TO BE SET TO HELIUM FOR AT LEAST 140 SCFH THE BOTH USE CGA-580 CONECTION INLET. WHAT COULD HAPPEN IS THAT YOUR OLD FLOWMETER WAS STORED FOR QUITE SOME TIME AND THE DIAPRAGM WAS RUSTED OR ...

6011 OR 6010 HAS A VERY HIGH PENETRATION RATIO.

AND 3/32 SHOULD DO FINE JUST MINGLE WITH AMPERAGE WITHOUT OVERHEATING AS IT WILL CAUSE YOUR ROD TO PERFORATE AND YOUR ADVANCE SPEED SHOULD BE A TAD FASTER USING MORE AMPERAGE.

BEST REWARDS
BLUE BLOOD

WHAT IS THE THICKNESS OF THE PIPE USUALLY FOR JOINING THAT 3/32 GAP YOU SHOULD TRY A HIGH PENETRATION ROD. LIKE 6010 OR SIMILAR. FOR YOUR HOT PASS TRY LINCOLN 7010 YOU SHOULD SEE THE DIFFERENCE RIGHT AWAY. AND THE LAST PASS YOU SHOULD DO A LINCOLN 7018 TRY THIS AND COMENT ON IT YOU SHOULD BE FINE. B...

YOU SHOULD DO ACEP, AND YOU SHOULD BE FINE.

ALSO IF YOU CAN CONSTANT CURRENT EP. WILL BE BETTER.
ALSO MAYBE YOU SHOULD TRY ABOUT 90 AMPS


TELL ME IF IT WORK
BLUE BLOOD

YOU NEED TO REFER TO THE DEPARTMENT OF ACQUISITIONS FIRST LET THEM KNOW YOU EXIST, THEN TRY PRODUCTION DEPARTMENT OR MAINTENCE DEPARTMENT, LAST BUT NOT LEAST TRY

GOOD LUCK BEST REWARDS

A LITTLE BLUE BLOOD LOVER (MILLER)

TRY 312 ITS THE ONE TO WELD DISSIMILAR STEELS

GOOD LUCK.

IT LOOKS GOOD FOR A FIRST TIME EXPERIENCE, TRY PLAYING WITH THE WIRE SPEED A LITTLE, UP OR DOWN. ALSO TRY TO WELD ON A FLAT POSITION IT WILL BE A BETTER LOOKING WELD. AND WHEN YOU DO THIS TRY SOMETHING LIKE A ZIG-ZAG ABOUT 1/4 IN. APART, AND STAY TWICE AS LONG ON THE BOTTOM PUT IT THIS WAY IN FLAT O...

tell me de serial number, and i will print a technical diagram for it

im a authorized distributor for miller electric in northern mexico.

best rewards

WE NEED SOMO HELP FROM ALL OF YOU FOLKS, HERE IS THE DEAL, WE ARE TRING TO RESTRICT PEAK FLOWS FROM A LINE THAT RUNS FROM FLOWMETER TO WIRE FEEDER ABOUT 30 TO 50 FEET LONG, ADD ANOTHER 25 FEET OF TORCH AND VOILA WE NEED TO CUT ON GAS CONSUMPTION, WE ARE THINKING GAS FLOW RESTRICTOR BEFORE SOLENOID V...