ok forgot i had no wire left lol

i had 6 metres coiled up on the wall so i did a wire feed speed test

on highest feed it is 530" per minute 53 " over 6 seconds

on highest output it is 18.5v @ 90 amps

is this okay you think ?

awesome will give it a go might just do a fillet weld on a T and cut it and have a look at penetration

i have 90amp mig flux cored .8mm or .031" welding 3mm near enuf to 1/8"

This is a lap joint it is 50mm x 50mm square 3mmT to 3mm box section joint

will this be ok strong enuff ?

if so what technique

Thanks Col