Sorry, I was going for 0.5mm to 1mm. That's should be 0.02 to 0.04". Hope that's right. I devided mm/25.4. 0.02 is still very thin. May 4 amp be to much? Isn't also the quality of the arc very important at low amps? I understand that it takes practise, but I mean if the machine is too "clu...

@Oscar It's a lot of money. When I decide I will try to get a refurbished one. I think. I justifies the high price with some savings I can make. One of them is an air to air heat exchanger. They start at 2500 euro and I can probably build it for half. Maybe a third. The thinner aluminum the better I...

@VA-Sawyer I also thought that was interesting. The video with the bike builder. There are some Chinese brands with independent AC but the specifications isn't that good. I will probably go for the Stel 221 with independent ac. They are above the Chinese in quality and also price. They have a awful ...

Mixed AC/DC is one part AC(DC+ alternating with DC-) at least one cycle, and one part DC+ or DC-(not alternating). And then it starts over. AC(DC+ and DC-) followed by DC+ or DC-. On the Aland machine the everlast255ext uses DC- for the last cycle. Everlast calls it Advanced AC Pulse. Independent AC...

Hi! :) The manual claims the AC is independently set. This can't be true? I have mailed everlast about this. No response. Page 19 point 21: The unit features two pulse modes. The standard mode is available in AC and DC modes. The Advanced AC mode, works only in AC. Pulse is used to control heat inpu...